3
BBG-1002-UDX Function Menu List and Descriptions
3-14
BBG-1002-UDX PRODUCT MANUAL
BBG1002UDX-OM (V1.5)
(continued)
• Noise Reduction/Detail Enhancement
Controls
Provides individual Noise Reduction and Detail Enhancement controls for
optimizing scaled output where source is not optimum for scaled format.
•
Frame Rate Conversion (FRC)
Controls
Provides controls for enabling FRC and setting the type and
aggressiveness of FRC to be applied.
• FRC Enable/Aggressiveness Control
Enables/bypasses FRC and sets aggressiveness as follows:
• Bypass: This setting is used when FRC is not to be used. The Bypass
setting restores the device minimum latency.
If a scaler output frame rate is selected where FRC is
required (for example 1080i5994 to 1080i50), this control
must not be set to Bypass. Severe video/audio corruption
such as frame jumps, drop-out, and audio hits will result if
set to Bypass.
• Level 0: This setting provides a basic, low-latency FRC which
accomplishes FRC by dropping or duping frames as required.
Depending on content, this setting can in some cases provide
adequate subjective results.
• Level 1 thru Level 3: These settings provide choices of non-dup/
drop true conversion where a transitioning frames is blended from a
preceding frame to the subsequent frame.
Level 3 derives most transitional content from the subsequent
frame, resulting in optimized motion fluidity and very minor
softening of the frame image as a trade-off.
Level 1 provides most transitional content from the preceding
frame, resulting in optimized frame image sharpness with a slight
reduction in motion fluidity.
Level 2 provides a balance of attributes between levels 1 and 3.
Note: Extensive engineering and subjective analysis supports the
recommending of Level 3 as the preferred setting for most content
types.
• Output Format Selector (with FRC)
With FRC, the Output Format drop-down offers the same raster
selections as shown for the base Output Format drop-down shown
above, but has additional, frame-rate specific choices also availed (as
shown here showing full range of applicable NTSC and PAL rates for
720p).
Note: See Figure 1-4, FRC Standards Conversion Matrix in
Chapter 1 – Introduction for a complete list of input/output
conversions available.
Table 3-2
BBG-1002-UDX-UDX Function Menu List — continued
