1)
ON LATCH SIDE-
LOCATE THE DROP BAR POSITION— Made sure that you position the back pivot plate
so the drop bar over hangs the edge of the gate by NO MORE then 1-3/4”.
A.
DRILL 1/8” SCREW PILOT HOLES (2)
B.
MOUNT THE PIVOT PLATE with 2 screws.
2)
MOUNT THE KEEPER PLATE
with two SCREWS on the outside edge of the gate with the
DROP BAR protruding though the KEEPER. Make sure that the KEEPER is on the edge on the
gate and the drop bar is horizontal.
3)
MOUNT THE CATCH PLATE
on the vertical post or frame at the rest position of the DROP
BAR with 2 remaining SCREWS. Make sure that there is no more then ¾” between the
KEEPER and the CATCH.
