Coachman 2022, Руководство пользователя

Страница: 38 / 208

Connecting ser vices - Water
37
O
w
ners h
andb
o
ok
2
02
2
Water
Your caravan will be fitted with a
Whale IC pump.
Under no circumstances should mains
water be connected to the caravan
without a pressure reducer.
If using the system after a storage
period, carry out checks as outlined in
“Setting up the Water System”.
Fill fresh water container and place in
suitable position. Place waste water
receptacles in position.
Place the submersible pump or filler
pipe into the water container, ensuring
that it is fully submerged before
operating the system.
Waste connection
Your caravan is fitted with a 28mm waste
water system. Two waste water outlets
are located on the offside of the caravan
to the rear of the wheels.
These outlets connect to a standard
waste hose, which can then be inserted
into suitable waste water containers.
Pressurised water system
Fresh water is supplied to the caravan
from either an internal or external pump.
WHALE principles of operation
The Watermaster® IC is a means of
control for the Whale Watermaster® High
Flow pump, which allows it to operate
without the need for pressure switch
adjustment. It offers three key features:
eliminates a rapid water pulsation,
ensures that the pump turns off at low
battery voltages and also in a run-dry
situation when the water supply runs out.
This Intelligent Control® is achieved as
the pressure switch turns the pump
on when the pressure drops to a low
level and the microprocessor turning
off the pump at programmed current
levels. These current levels are set
during the simple calibration process.
This calibration process may have to be
repeated if the pump is replaced, or after
the vehicle has been serviced.
Connecting your plug and
pump kit
Prior to using your water system for the first
time, the system will need to be primed and
the Watermaster® IC unit will need to be
calibrated by the following simple steps.
To prime the water system
Step one - Place the pump into a full
water container. Ensure the pump can
reach the bottom.
Step two - Insert Easi-Push plug into
socket and slide the lid to lock into place
see Fig.1 above.
Fig.1