1
TNG_HOWTO_PGMBLTPK_D0000080_2014_REVB How to Program a Tempest NG BeltPack 1.31.2014
Tempest NG
Program a BeltPack to a BaseStation
Introduction
Tempest BeltPacks are programmed to their respective BaseStations. In the event a new BeltPack is added to a BaseStation or an
existing BeltPack is serviced, it may be necessary to pair that unit to the existing BaseStation. The purpose of this document is to
outline the steps for programming a BeltPack to a specific BaseStation.
Note: If you are re-programming existing BeltPacks to a new or serviced BaseStation, it is recommended to “Clear Memory” on each
BeltPack before beginning the programming process. See “Clear Memory” Section below for more information.
Firmware
Your new unit has the latest firmware version available on the Tempest NG system. In order to ensure compatibility and optimal
performance from your new unit, it is extremely important that you update your existing system firmware to match the firmware of
your new unit. Both the Tempest NG BaseStation and the BeltPacks must be updated.
To verify your current version of firmware, you can view it on the displays of your BaseStation and BeltPacks as you power them on.
The firmware will be a 6-digit numerical sequence (e.g. DSP 06.00.00 or PIC 02.00.00). If your new unit’s firmware matches your
existing system firmware, then no update is required.
If you need technical assistance with updating your firmware, or if you have any questions do not hesitate to contact us at
1.800.749.2761.
Required Equipment
-
Tempest NG BaseStation
-
Tempest NG Transceiver
-
Tempest NG BeltPack
-
Programming cable (3.5mm Male-to-Male mini-stereo cable). This cable should have been provided with new BeltPack;
however, it is a standard audio cable found at any retail audio store.
Programming (or Pairing) BeltPacks
Follow these steps in order to program your new or serviced BeltPack to a designated BaseStation (note that BaseStation and
BeltPack should be powered OFF when beginning):
1.
With BaseStation power OFF, plug Transceiver into BaseStation
a.
If the BaseStation and Transceiver are already set up and ready, there is no need to cycle the power
2.
Power ON BaseStation (if applicable)
3.
Plug one end of pairing cable into BaseStation and the other into BeltStation
4.
Power ON BeltPack
a.
Pay attention to the LCD display of the BeltPack during power up – it should state “Pairing Complete” if a
successful pairing has taken place
b.
If it does not say “Pairing Complete” it could have a bad connection where the cable plugs into the BeltPack.
Power cycle and hold cable in tightly during power up to ensure a proper connection is being made
c.
Once paired, the main status screen will read “Encryption Error” or “Slot Occupied” if other BeltPacks are ON and
logged into the same BaseStation
5.
Once programmed, follow the steps below for setting
Security Codes
and
Slot Assignment
®
®
