AN103
Rev 1.0 | Page 6 / 23
www.cmostek.com
2. Application Schemes
The Development Kits can be used in 2 different application schemes.
Evaluation Scheme
:
Main product features can be configured and evaluated/demonstrated in this
scheme.
Configuration Scheme
:
All product features of can be configured in this scheme.
2.1 Evaluation Scheme
The necessary components of the evaluation scheme are:
Two RF-EBs
CMT2110A-EM
CMT2210A-EM
Main product features can be evaluated and demonstrated in this scheme. Follow the step-by-step instructions to
start working in the Evaluation Scheme.
1. Turn off the RF-EB power switch (SW1, see Figure 6 in Page 10). It is always good practice to plug in or out
the evaluation modules after the RF-EB is powered off.
2. Switch the Power Mode Jumper (J7, see Figure 6 in Page 10) to the USB or BAT side to select the available
power supply source.
3. Plug the evaluation modules into both RF-EBs respectively. Please note that there are 2 sets of evaluation
modules and antennas, the user should pair them properly according to their frequency labeled on them.
4. Turn on the power switch (SW1) of the RF-EB. The LED indicator for the power supply indication will be light
up to show to “ON” status of the RF-EB.
5. Start to configure the evaluation modules according to the instructions displayed on the LCD and then
evaluate the main features/performance.
2.2 Configuration Scheme
The necessary components of the configuration scheme are:
RFPDK
USB Programmer
CMT2110A-EM or CMT2210-EM
This scheme allows the user to freely customize all product features and program them into the chips. Once the
programming is done successfully, the evaluation module is ready to be integrated into the user’s own application
systems. Moreover, the users can program chip configurations to their self-designed CMT2110A/2210A modules
as long as the programming interface is reserved.
