CMF Power Select, Инструкция по установке и эксплуатации, Страница: 27 / 40

Installation / Operation Instructions
CMF Power Select Ver. 3.0
REV 6.3
26
6 Maintenance
6.1
The hydraulic system is sealed from the atmosphere, preventing the leakage of oil or the
ingestion of dirt. The oil, a high grade of hydraulic fluid with a -60 degree pour point, is
filtered at the factory before installation. It is recommended that the system remain sealed
throughout the life of the unit to prevent contaminants from being introduced into the
circuits.
6.2
The electrical system is comprised mainly of solid state components which require no
maintenance over the life of the Power Select, even under severe operating conditions.
The few mechanical switches in the system are heavy duty industrial type switches also
sized to require no maintenance over the life of the Power Select.
6.3 Annual Maintenance
6.3.1 Remove the inspection covers from Power Select and check solenoid cables and
sensor cables for signs of chafing or cracks in the insulation and replace as
required.
6.3.2 Check hydraulic lines and fittings for signs of leakage and correct as required.
6.3.3 Clear away any accumulation of dust or material from inside the unit to prevent
sticking of the slides.
6.3.4 Remove any accumulation of dust or material from the inside bottom of the
distributor housing.
6.3.5 Inspect all mounting bolts on Power Select for signs of loosening and tighten as
required.
6.3.6 Check the level of hydraulic fluid in the reservoir.
6.3.7 Replace all covers.