1
STEP
WALL
DRAIN
8"
FLOOR DRAIN
Connect a 2" drain pipe (not supplied) from scrap
accumulator to floor or wall drain.
3 Phase: Connect power supply wires, L1, L2 and L3
to the appropriate terminals marked L1, L2 and L3 on
the power block.
Important: If one of the three wires
has higher voltage it must be inserted as L-2.
4
STEP
L2
L3
L1
208/240
3 PHASE OR SINGLE
PHASE
L1 AND L3
FOR SINGLE PHASE
11-2016
CMA-180VL-FL
REAR VIEW
WARNING
: Electrical and
plumbing connections need
to be made by a licensed
service person and comply
with all Federal, State and
Local Health, Electrical,
Plumbing and Safety codes.
CMA-180VL-FL
Quick Setup
Instructions
DRAIN
CONNECTION
1
DETERGENT
FITTING INLET
5
HOT WATER
INLET
2
MIXING
CHAMBER
6
POWER
BLOCK
4
COLD WATER INLET
LOCATED ON FRONT
OF MACHINE
3
PN: 10130.17
Connect cold water inlet (min 41°F and max 65°F).
(Review other side for details).
3
STEP
COLD WATER INLET
2
STEP
Connect dishmachine to hot water source 120°F -
140°F.
HOT WATER INLET
Remove the plastic plug to install the detergent
fitting (provided by your dispenser supplier;
CMA does not supply).
5
STEP
PLASTIC
PLUG
Remove the plug from the mixing chamber and install
the rinse injection fitting (rinse injection fitting
provided by your dispenser supplier; CMA does not
supply).
6
STEP
