Club Car TransPorter 4, Руководство по техническому обслуживанию и ремонту

Страница: 43 / 286

BODY AND TRIM Rear Fenders and Tailskirt
4
REAR FENDER AND TAILSKIRT REMOVAL
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL and set the
park brake. Chock the wheels.
2. Disconnect the battery cables and either discharge the controller or disconnect the spark plug wire(s). See
Disconnecting the Batteries – Electric Vehicles, Section 1, Page 1-3.
3. Remove the tilt bed. See Tilt Bed Removal on page 4-12.
4. Disconnect the three taillight wires.
5. Using a 10 mm socket, remove the three fasteners (5) that attach the rear fender (4) to vehicle frame (Figure
4-8, Page 4-16) .
6. Using a 10 mm socket, remove the two M6 screws (2) that attach the tailskirt (3) to the vehicle frame.
7. Remove fenders and tailskirt.
REAR FENDER AND TAILSKIRT INSTALLATION
1. Using a 10 mm socket, install the two screws (2) that attach the tailskirt (3) to the vehicle frame (Figure 4-8,
Page 4-16) . Tighten to 44 in·lb (5 N·m).
2. Using a 10 mm socket, install the three fasteners (5) that attach the rear fender (4) to the vehicle frame. Tighten
to 5 in·lb (0.56 N·m). Do not over torque.
3. Connect the taillight wires.
4. Install the two bolts and nuts that secure taillight to the rear fender.
5. Connect the three taillight wires.
6. Install the tilt bed. See Tilt Bed Installation on page 4-12.
7. Connect the batteries. See Connecting the Batteries – Electric Vehicles on page 1-4.
2019 Transporter Maintenance and Service Manual Page 4-17