Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 338 / 414

21
Engine Control Linkages GASOLINE VEHICLE - FUEL SYSTEM
2.3. Push bellows back onto threaded end of cable housing.
2.4. Connect “Z” fitting of governor cable (1) to governor arm (4).
3. Loosen adjustment screw jam nuts (6 and 10) and back off throttle stop screw (7) and power limiter screw (11)
several turns
(Figure 21-7, Page 21-10) .
4. Rotate governor arm (4) counterclockwise until it stops and hold in this position (Figure 21-7, Page 21-10) .
5. Adjust governor cable jam nuts until throttle lever (2) is at “wide open throttle” (WOT) (Figure 21-5, Page 21-9)
and tighten the governor cable jam nuts to 36 in·lb (4.0 N·m).
6. While still holding this position, adjust power limiter screw (11) (Figure 21-7, Page 21-10) to set distance (B)
at 2.87 in. (±0.039) (1.4 mm (±1)) as shown (Figure 21-5, Page 21-9) between throttle lever (2) and throttle
body bracket (3). Tighten limiter screw jam nut (10) to 36 in·lb (4.0 N·m).
7. Release governor arm (4) to return to “idle” position.
8. Adjust gap (A) between governor arm (4) and throttle stop screw (7) to 0.055 in. (±0.039) (1.4 mm (±1)) as shown
(Figure 21-7, Page 21-10) . Tighten stop screw jam nut (6) to 36 in·lb (4.0 N·m).
9. Check engine RPM adjustment. See Engine RPM Adjustment on page 21-13.
4
5
1
9
8
13
A = 0.055 in. ± 0.039 (1.4 mm ± 1)
3130
Figure 21-6 Governor and Accelerator Cables At Governor
Arm
3131
Figure 21-7 Throttle Stop Screw Gap
ACCELERATOR CABLE
Accelerator Cable Removal
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Disconnect battery and spark plug wire(s).
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3. At transaxle:
3.1. Unhook spring fitting of accelerator cable (8) from governor arm (4) (Figure 21-6, Page 21-10) .
3.2. Unsnap accelerator cable (8) from FNR/accelerator cable bracket (9).
4. At pedal group:
4.1. Access the pedal group and disconnect accelerator cable clip from the accelerator pedal. See Pedal
Group Removal on page 5-4.
4.2. Loosen jam nuts securing accelerator cable to underbody and remove accelerator cable (9) from vehicle
(Figure 5-4, Page 5-5) .
Page 21-10 2019 Precedent Villager 2 Maintenance and Service Manual