Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 236 / 414

17
Transaxle Removal ELECTRIC VEHICLE - TRANSAXLE
767
Figure 17-8 Disconnect Shocks
2700
Figure 17-9 Shackles
12. If a floor jack was used, pull floor jack from beneath the transaxle and allow the springs to rest on the floor.
13. Remove the U-bolts attaching the transaxle to the leaf springs (Figure 17-10, Page 17-6) .
14. Carefully lift each end of the transaxle off its positioning pin (on the leaf spring) and slide the transaxle to the rear
and out of the vehicle.
15. Drain the lubricant from the transaxle and remove the axle shafts. See Axle Shaft and Oil Seal Removal on
page 17-1. See following NOTE.
NOTE: Recycle or dispose of used oil or lubricant in accordance with local, state, and federal regulations.
16. Remove the brake assemblies if required. See Brake Cluster Removal on page 6-9.
1
2
1. Villager 2 2. Villager 4
1
2
3
4
769
Figure 17-10 Leaf Springs
770
Figure 17-11 Motor Mounting Bolts
Page 17-6 2019 Precedent Villager 2 Maintenance and Service Manual