Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту, Страница: 156 / 414

12
Test Procedures
ELECTRIC VEHICLE - EXCEL SYSTEM
TROUBLESHOOTING
TEST PROCEDURE 12 – Motor Speed Sensor
See General Warnings on page 1-2.
Motor Speed Sensor Test without any Tool
CAUTION
• Perform the following procedure only on a level surface. To avoid injury or property damage, ensure
that the path of the vehicle is clear before pushing vehicle.
1. Place the Forward/Reverse switch in the REVERSE position to verify reverse buzzer is functioning properly. If
not, repair or replace the buzzer.
2. With Tow/Run switch in the RUN position, turn the key switch to the OFF position and place the Forward/Reverse
switch in the NEUTRAL position.
3. Slowly push the vehicle a short distance (about 3 feet (1 meter)). The reverse buzzer should sound and motor
braking should engage while the vehicle is rolling.
4. If the reverse buzzer does not sound and motor braking does not engage while the vehicle is rolling, replace
the Motor Speed Sensor.
Motor Speed Sensor Test with the CDT Handset
CAUTION
• Perform the following procedure only on a level surface. To avoid injury or property damage, ensure
that the path of the vehicle is clear before pushing vehicle.
1. Turn the key switch to the OFF position and place the Forward/Reverse switch in the NEUTRAL position.
2. Connect the CDT to the vehicle.
3. Access the Monitor menu and select SPEED PULSES by using the SCROLL DISPLAY buttons. The CDT should
indicate OFF when the vehicle is at rest.
4. While monitoring the CDT display screen, slowly push the vehicle a short distance (about 3 feet (1 meter)). The
CDT should indicate ON for speed sensor pulses while the wheels are in motion.
5. If the CDT does not indicate ON while the wheels are in motion, proceed to the following procedure.
Motor Speed Sensor Test without the CDT Handset
NOTE: This is a voltage test.
1. Turn the key switch to the OFF position and place the Forward/Reverse switch in the NEUTRAL position.
2. With batteries connected, disconnect the three-pin connector at the motor speed sensor.
3. Check voltage at purple/white wire:
3.1. Using a multimeter set to 200 volts DC, place the red (+) probe on the battery no. 1 positive post and
place the black (–) probe on the purple/white wire terminal socket in the three-pin connector. The voltage
reading should be 48 to 50 volts (full battery voltage).
3.2. If the reading is zero volts, check the continuity of the purple/white wire from the 16-pin connector at
the speed controller to the three-pin connector at the motor speed sensor. If the continuity is correct,
replace the speed controller.
4. Check voltage at the red motor speed sensor wire:
Page 12-24 2019 Precedent Villager 2 Maintenance and Service Manual