Club Car Precedent 2014, Руководство по техническому обслуживанию и ремонту

Страница: 347 / 548

FUEL SYSTEM Carburetor
22
MAIN JET ELEVATION/SIZE CHART
JET SIZE
KAWASAKI FE350
ENGINE
MODEL/REVISION
CARBURETOR
NUMBER
0 TO 3300 FT.
(0 TO 1000 M)
3300 TO 9900 FT.
(1000 TO 3000 M)
9900 FT. AND HIGHER
(3000 M AND HIGHER)
32282
AS02, BS02
AS03, CS03, DS03
32337
BS03 32478
32571
32642
32740
AS10 to FS10
AS11 to FS11
AS23
AS24
42051
AS26 to current 42081
85 82 80
AS27 to current 42082 82 80 78
CHANGING THE MAIN JET
See General Warnings on page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-3.
2. Remove the carburetor.
2.1. Turn fuel shut-off valve on fuel tank to the closed (OFF) position (Figure 22-13, Page 22-21) .
2.2. Loosen the intake air hose clamp (22) and disconnect the intake air hose (23) at the carburetor end only
(Figure 22-1, Page 22-2) .
2.3. Remove the governor guard (5).
2.4. Disconnect the governor cable (30) from the carburetor.
2.5. Disconnect the carburetor vent line (14).
2.6. Disconnect the fuel supply line (26) at the carburetor end only. Temporarily plug the end of the fuel line to
prevent fuel leakage.
2.7. Remove the carburetor retaining nuts (19), intake pipe (17), and carburetor (12). See following NOTE.
NOTE: Note the orientation of the gasket (16), between the carburetor intake pipe (17) and the carburetor body (12)
so that it can be replaced in the same orientation (Figure 22-1, Page 22-2) .
When removing the carburetor body, the throttle return spring (11) must be disconnected. Note its proper
orientation so that it can be replaced in the same orientation.
The carburetor must be kept upright during removal.
3. Position the carburetor with the drain screw (11) over a catch basin (Figure 22-4, Page 22-4) .
4. Turn the carburetor bowl drain screw counterclockwise two or three turns and drain all the fuel from the bowl
into the catch basin
(Figure 22-2, Page 22-4) . Tighten the drain screw to 10 in·lb (1.1 N·m). Return fuel to the
fuel tank or dispose of properly.
5. Mark the body of the carburetor and the carburetor fuel bowl with an indelible ink marker so that, after removal,
the bowl can be installed again in the same position
(Figure 22-3, Page 22-4) .
2014 Precedent ® Golf Car Maintenance and Service Manual Page 22-3