Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 151 / 344

TROUBLESHOOTING AND ELECTRICAL SYSTEM Test Procedures
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 11-43
11
6. Pull the light switch to the ON position The reading should be 11-12 volts. If the there is no voltage
reading, check continuity of the 16 gauge black wire from the headlight to the headlight diode. Check
continuity of the 16 gauge black wire from headlight diode to the vehicle frame. If the wires show conti-
nuity and the readings are still incorrect, replace the headlight diode. See Headlight Diode Removal,
Section 12, Page 12-29.
7. With the Forward/Reverse handle in the NEUTRAL position and the wheels chocked, start the engine
and depress the accelerator pedal to the floor.
8. Push the light switch to the OFF position. The reading should be 14.7-15.3 volts.
9. Pull the light switch to the ON position. The reading should be 11-13 volts. If the reading does not drop
from 14.5-15.5 volts to 11-13 volts, replace the headlight diode.
TEST PROCEDURE 30 – VOLTAGE AT HEADLIGHT SOCKET
Read DANGER and WARNING on page 11-1.
NOTE: Keep the battery connected while performing this test procedure.
1. Place the Forward/Reverse handle in the NEUTRAL position, and chock the wheels.
2. Inspect wires at the light bulb socket. Make sure wires are securely fastened to the contacts inside
socket.
3. Remove the wiring harness from the headlight (Figure 11-49, Page 11-44).
4. Using a multimeter set to 20 volts DC, place the black (–) probe of multimeter into the black wire termi-
nal of the wiring harness. Place the red (+) probe into the blue wire terminal.
5. Pull the light switch to the ON position. If the multimeter reads approximately 12 volts, replace the
headlight bulb.
Figure 11-48 Headlight Diode Circuit Test
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM 200nA
MAX
1000 ---
750V
FUSED
YELLOW
BLACK
LIGHT
SWITCH
FRAME
GROUND
VOLTAGE
LIMITER
BLUE
BLACK
BLACK