Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 219 / 280

S27 FE 350 FUEL SYSTEM Choke and Air Intake System
16
2. Guide air duct into the hole at the front of the air box assembly mounting plate. Position air duct so the air box
will fit correctly onto the air duct.
3. Install two pop rivets (25) and four flat washers (26) to secure air duct retaining bracket (27) around air duct
as shown
(Figure 16-12, Page 16-14) .
4. Install air box assembly. See Air Box Installation on page 16-15.
INTAKE DUCT REPAIR
If the air intake duct is damaged, it will need to be replaced.
AIR FILTER
General Information
The air filter should be checked every year or 100 hours. More frequent service may be required in extremely dirty
operating environments. Need for immediate servicing will be indicated by a loss of power, sluggish acceleration, or an
engine which runs roughly with excessive black exhaust smoke.
Air Filter Replacement
1. Lift two latches (3) on the side of the air box (Figure 16-11, Page 16-13 and Figure 16-12, Page 16-14) .
2. Remove the hose clamp (15) from the air hose and remove hose from the air box assembly.
3. Standing on driver side of vehicle, grasp air hose mounting inlet and open box fully. Remove filter element (12).
4. Using a clean cloth, wipe away any dust or dirt from inside the air box. Remove all dirt build-up around the
inside lip of the box or the box will not seal properly.
5. Install new air filter by inserting back edge first, and pushing down using the palm of your hand to seat filter
evenly onto inside lip of air box. Ensure filter fits correctly and that the wire latches are not caught between
lid and air box. Close the lid.
6. Fasten wire latches (3). Make sure latches securely engage the bottom half of the box. See following CAUTION.
CAUTION
• Engine damage will occur if the air box cover is not properly secured.
• If air box is extremely dirty, remove air box from vehicle and clean thoroughly.
• Use only Club Car replacement air filters (CCI P/N 1015426). The use of other air filters could result
in engine damage. If the air filter is too thin, the cover will seat before the filter can seal, leaving
space for dirt to pass into the engine on all sides of the element. This will damage the engine and
void the warranty.
7. Install hose (16) and hose clamp (15) (Figure 16-11, Page 16-13 and Figure 16-12, Page 16-14) . If equipped
with screw clamp, tighten to 17 in-lb (1.9 N·m). Make sure clamp ends are located in the 12:00 o’clock position.
2009 FE 350 Maintenance and Service Supplement Page 16-17