Club Car Carryall XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 199 / 432

TROUBLESHOOTING AND ELECTRICAL SYSTEM:
DIESEL VEHICLES Test Procedures
12
– Check the 30-amp fuse (on w125). See Test Procedure 2 – Fuse on page 12-13.
– Check the key switch. See Test Procedure 4 – Key Switch (Starter Circuit) on page 12-15.
– Check the neutral switch on the transmission housing. See Test Procedure 17 – Neutral Switch
(Transmission) on page 12-28.
– Check for continuity of the wire harness on wires w141, w138, w110, and w125. See Wiring Diagram on
page 12-6.
TEST PROCEDURE 9 – Fan Relay
See General Warnings, Section 1, Page 1-2.
The fan relay activates the radiator fan when the engine coolant reaches a temperature range of 187 °F to 198 °F
(86 °C to 92 °C) and closes the fan thermostat switch.
1. Disable the vehicle. See Disabling the Vehicle on page 1-3.
2. Disconnect the 16-gauge green wire (w127) from the starter solenoid coil to prevent the vehicle from
unintentionally starting
(Figure 12-11, Page 12-17) . See following WARNING.
WARNING
• Failure to disconnect the wire from the solenoid coil could result in an unexpected engine start
when performing this test.
3. Check power to the relay.
3.1. Set the multimeter to 20 VDC and place the probes to measure the voltage between the 18-gauge yellow
fan relay wire (w146) terminal and the frame ground (Figure 12-15, Page 12-20) .
3.2. Monitor the multimeter. The reading should indicate 0 volts with the key in the OFF position. If not, check
for a short or incorrect wiring between the yellow fan relay wire (w146) terminal and the key switch.
3.3. The reading should indicate approximately 12 VDC with key in the ON position. If so, proceed to step
4. If not, perform the following test procedures:
– Check battery.
See Test Procedure 1 – Battery on page 12-10.
– Check the 30-amp fuse (on w125). See Test Procedure 2 – Fuse on page 12-13.
– Check the key switch. See Test Procedure 5 – Key Switch (ON Position) on page 12-16.
– Check diode 2. See Test Procedure 14 – Diode 2 on wire 40 on page 12-25.
– Check for continuity of the wire harness on wires w114, w146, w121, w48, w37, w24, and w125. See
Wiring Diagram on page 12-6.
– Check the engine coolant thermostat switch. See Test Procedure 10 – Thermostat Switch on page
12-20.
4. If the reading is 12 VDC with key in the ON position, check relay function.
4.1. At the relay, place the meter probes to check continuity between the 14-gauge yellow wire (w107) and the
14-gauge blue wire (w145) relay terminals (Figure 12-16, Page 12-20) when the relay is activated.
4.2. At the relay, ground the yellow/black fan relay wire (w114) to the frame with a jumper wire.
4.3. Turn the key switch ON. The relay should click, the fan should run and the meter should indicate continuity.
See following NOTE. If not, replace the relay.
NOTE: The start and accessory relays may be removed temporarily to isolate the sound of the fan relay click.
2013 Carryall 295/XRT 1550 Maintenance and Service Manual Page 12-19