Club Car Carryall XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 194 / 432

12
Test Procedures
TROUBLESHOOTING AND ELECTRICAL
SYSTEM: DIESEL VEHICLES
2105
Figure 12-7 Electrical Component Mounting Plate
TEST PROCEDURE 3 – Ground Cables
See General Warnings, Section 1, Page 1-2.
1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Check the frame ground connection for loose connections and damaged terminals (Figure 12-8, Page 12-15) .
Repair or replace as required.
3. Check the negative (–) battery terminal and 6-gauge black wire (w202) for damage. Repair or replace as required.
4. Check the engine ground for a loose connection, damaged terminals and an excess of paint on the engine
block (under the starter) where the two 6-gauge black wires (w202 and w203) are connected
(Figure 12-9,
Page 12-15) . Repair or replace as required.
5. Set the multimeter to 200 ohms.
6. Check for continuity between the 6-gauge wire (w202) terminal, disconnected from the negative (–) battery
terminal, and the frame.
7. Check for continuity between the 6-gauge wire (w203) terminal, disconnected from the negative (–) battery
terminal, and the engine.
8. The readings obtained in the previous steps should indicate continuity. If any of the readings are incorrect, clean
and tighten wire connections. If the connections are good and the reading is incorrect, repair or replace the wire.
Page 12-14 2013 Carryall 295/XRT 1550 Maintenance and Service Manual