Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 82 / 456

6
Brake Adjustment WHEEL BRAKE ASSEMBLIES
TIPS
2808
Figure 6-13 Insert Shoes
2800
Figure 6-14 Position Shoes
CAUTION
• Clean any residual oil from the exposed end of the axle shaft and from the oil seal area prior to
installing the axle shaft.
6. For electric vehicles: Install the axle shaft. See Axle Shaft and Oil Seal Installation, Section 17, Page 17-4.
For gasoline vehicles: Install the wheel hub assembly. See Rear Hub Installation, Section 26, Page 26-4.
7. Install the brake drum and make sure that it is properly seated. See following NOTE.
NOTE: If drum installation is difficult, the brake shoes may need to be adjusted vertically in the mounting slots.
8. After the drum is installed, make sure the axle and drum turn freely.
BRAKE ADJUSTMENT
See General Warnings on page 1-1. See also Asbestos Dust Warning on page 6-1.
CAUTION
– Pedal group adjustment must be within specifications prior to beginning brake adjustment. Perform
the appropriate pedal group adjustment.
– For gasoline vehicles, refer to Pedal Group Adjustment – Gasoline Vehicles on page 5-10.
– For electric vehicles, refer to Pedal Group Adjustment – Electric Vehicles on page 5-16.
NOTE: All brake cluster components must be clean, lubricated, and in good working condition prior to beginning
brake adjustment.
All wheels must be installed on the vehicle and lug nuts tightened to 65 ft·lb (88 N·m).
Page 6-6 2017 Carryall 500 and 700 Maintenance and Service Manual