Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 427 / 456

CLUTCHES: GASOLINE VEHICLES Driven Clutch
25
5. Cam, Driven Clutch 11. Sheave, Fixed, Driven
6. Spring, Driven Clutch, 55 Degree 12. Key, 3/16 in. (4.7 mm) Square X 1.50 in. (38 mm) Long
2961
Figure 25-14 Driven Clutch – Exploded View
DRIVEN CLUTCH REMOVAL
1. Remove the drive belt as instructed. See Drive Belt Removal on page 25-3.
2. Remove the bolt (1) and mounting washer (2) from the transaxle input shaft (Figure 25-14, Page 25-12) .
3. Grasp the driven clutch assembly and slide it off the shaft.
4. Leave the key (12) in the keyway.
DRIVEN CLUTCH DISASSEMBLY
CAUTION
• The driven clutch is balanced as an assembly. Before disassembly, make match marks on the driven
clutch fixed sheave and moveable sheave so they can be reassembled in the same positions.
1. Make match marks on the driven clutch fixed sheave and on the moveable sheave to maintain balance upon
reassembly.
2. Using external snap ring pliers, remove the retaining ring (4) (Figure 25-15, Page 25-14) . See following
WARNING.
WARNING
• Do not place fingers under the cam when removing the cam. The moveable face may spin when the
cam buttons release from the cam ramps, resulting in severe personal injury.
3. Insert a puller plug (2) (CC P/N 1014507) (Figure 25-16, Page 25-14) into the shaft bore and use a driven clutch
cam puller (1) (CC P/N 1014508) to remove the cam (3) from the fixed sheave.
4. Remove the spring (6) (Figure 25-14, Page 25-12) .
5. Retain the key (4).
6. Slide the moveable sheave (9) off the fixed sheave (11).
2017 Carryall 500 and 700 Maintenance and Service Manual Page 25-13