Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 353 / 456

ELECTRICAL COMPONENTS: PEDAL-START
GAS VEHICLE Reverse Warning Buzzer
20
20
1
15
8
12
11
10
9
16
21
13
2948
Figure 20-20 Accelerator Starter and Kill Limit Switches
REVERSE WARNING BUZZER
See General Warnings on page 1-1.
TESTING THE REVERSE WARNING BUZZER
See Test Procedure 17 – Reverse Buzzer and Reverse Buzzer Limit Switch on page 18-36.
REVERSE WARNING BUZZER REMOVAL
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery-Gasoline Vehicles on page 1-5.
2. Remove the instrument panel. See Instrument Panel Removal, Section 4, Page 4-10.
3. Disconnect the wires from the reverse warning buzzer (2) (Figure 20-21, Page 20-24) . Do not allow wires to touch.
4. Remove the mounting screws (1) securing the buzzer (2) to the instrument panel.
REVERSE WARNING BUZZER INSTALLATION
1. Install the screws (1) through the buzzer (2) mounting tabs and tighten to 3.5 in·lb (0.40 N·m) (Figure 20-21,
Page 20-24) .
2. Connect the black wire from the key switch to the negative (–) terminal on the buzzer.
3. Connect the orange/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Install instrument panel. See Instrument Panel Installation, Section 4, Page 4-10. Be sure that the key switch
terminals cannot touch the frame and that the panel is properly seated and snapped in place.
5. Connect battery and spark plug wire(s). See Connecting the Battery-Gasoline Vehicles on page 1-5.
2017 Carryall 500 and 700 Maintenance and Service Manual Page 20-23