Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 227 / 456

BATTERIES: IQ PLUS ELECTRIC VEHICLES Battery Care
14
Establishing the Watering Interval for New Vehicles
If you do not already have a battery watering interval for your vehicles, manually check the battery water level weekly
to establish the correct watering interval. Thereafter, water batteries according to the established interval. During
periods of heavy use, add additional watering as required.
Single-Point Watering System (SPWS) Maintenance
1. For vehicles newly equipped with the Single-Point Watering System, the initial electrolyte level check on all
battery cells verifies that all the valves in the SPWS are functioning correctly.
See Periodic Service Schedules
on page 10-4. If a valve fails to open, the cell will eventually dry out. The initial one-time inspection of all cells
will identify any occurrence of a valve that fails to open. If a valve fails to close, it will become evident due to
the cell overflowing during routine watering. Either failure scenario is rare, but should be monitored in the initial
inspection and during routine watering sessions. Replace malfunctioning valves to ensure maximum battery
life.
See following CAUTION.
CAUTION
• After checking the electrolyte, fully tighten the battery caps to prevent electrolyte leakage.
2. After the initial six-week inspection, manually check the electrolyte level at least once per year, particularly after
long-term storage or any other period of vehicle inactivity.
See preceding CAUTION.
BATTERY CARE – VEHICLES WITHOUT THE SINGLE-POINT WATERING SYSTEM (SPWS)
To keep batteries in good working condition, follow this maintenance program on a regular basis:
1. Keep the batteries clean and free of corrosion. Wash tops and terminals of batteries with a solution of baking
soda and water; use 1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water. Rinse solution off of the batteries.
Do not allow this solution to enter the battery. Be sure terminals are tight. Let the terminals dry and then coat with
Battery Terminal Protector Spray.
See following NOTE.
NOTE: Dispose of waste water properly.
2. Check the electrolyte level weekly (Figure 14-3) . Add water only after charging unless the electrolyte level is
below the top of the plates. In this case, add just enough water to cover the plates, charge, and then check the
level again. Never charge batteries if plates are exposed above electrolyte level. For best battery life, add only
distilled water.
See following CAUTION.
CAUTION
• Do not overfill the batteries.
NOTE: A battery watering gun or bottle (CC P/N AM10818) is available from your authorized Club Car dealer.
3. The battery hold-downs should be tight enough so that the batteries do not move while the vehicle is in motion,
but not so tight as to crack or buckle the battery case. Tighten hold-down retaining nuts to 55 in·lb (6.2 N·m).
The terminal connections should be clean and tight, and any worn insulation or frayed wires should be replaced.
Tighten battery terminals to proper torque.
See Connecting the Batteries – Electric Vehicles on page 1-4.
See following WARNING.
WARNING
• If battery wire terminals are damaged or corroded, replace or clean them as necessary. Failure to do
so can cause them to overheat during operation and can result in fire, property damage, or personal
injury.
2017 Carryall 500 and 700 Maintenance and Service Manual Page 14-9