Club Car Carryall 295 SE, Руководство по техническому обслуживанию и ремонту

Страница: 371 / 456

DRIVETRAIN COMPONENTS Rear Receiver Hitch
17
REAR RECEIVER HITCH
REAR RECEIVER HITCH REMOVAL
See General Warnings, Section 1, Page 1-2.
1. Disconnect battery and spark plug wire(s) (gasoline vehicles only) . See Disconnecting the Battery –
Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Remove the hydraulic line T-bracket from the passenger side of the receiver hitch.
3. Remove the hydraulic line from the rubber grommets and hitch frame.
4. Remove the four bolts, washers, and flanged locknuts from the receiver hitch frame and swing arm mounting
plates and remove the receiver hitch.
REAR RECEIVER HITCH INSTALLATION
1. Position the receiver hitch onto the swing arm mounting plates and mounting holes.
2. Secure the receiver hitch with new bolts, flat washers, and new flanged locknuts. Tighten the hardware to
82 ft-lb (111 N·m).
3. Secure the hydraulic brake line T-fitting and tighten the hardware to 48 in-lb (7 N·m) (Figure 17-11, Page 17-8) .
4. Secure the hydraulic brake line in the rubber grommets on the hitch frame.
5. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
2008-2012 All-Wheel Drive Maintenance and Service Manual Page 17-7