Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 299 / 312

TORQUE CONVERTER Driven Clutch
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual Page 17-15
17
5.1. Press Assembly Process:
5.1.1. Place the clutch assembly in a press and position the cam press tool (CC P/N 101809101)
on the cam as shown (Figure 17-19, Page 17-16) .
5.1.2. Hold the fixed face assembly (3) and rotate the moveable face assembly (1) one-third turn
clockwise, then press the cam (2) onto the fixed face assembly (Figure 17-19,
Page 17-16) .
5.1.3. Install the retaining ring (2) (Figure 17-16, Page 17-14) . See following NOTE.
NOTE: The cam has an interference fit with the keyed shaft and should remain in position when the cam
installation tool is removed, providing for the assembly of the retaining ring.
The retaining ring can be reused provided the O.D. does not exceed 1.607 inches (40.82 mm).
Otherwise it must be replaced with a new ring (CC P/N 1014080).
5.1.4. While holding onto the cam, tap the end of the fixed face shaft lightly with a plastic mallet
until the cam seats against the retaining ring. See following CAUTION.
CAUT ION
• Do not use a metal hammer to tap the fixed face hub. A metal hammer will damage the shaft.
5.2. Field Assembly Process:
Figure 17-17 Remove Retaining Ring Figure 17-18 Driven Clutch Disassembly
Using external snap
ring pliers, remove
retaining ring.
2
PULLER PLUG
Place puller plug in bore of
cam (A). Then clamp driven
clutch cam puller onto three
flat surfaces of the cam.
A
DRIVEN CLUTCH
CAM PULLER