Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 310 / 536

17
Engine Control Linkage S10 FE 350 FUEL SYSTEM
3
540
Figure 17-7 Cam Position – Parallel with Box (Top View)
541
Figure 17-8 Accelerator Rod – Pull Spring Release to
Attach (Bottom View)
7. Before tightening the jam nuts, set the park brake to the first latch and pawl position and check for proper
activation of switches.
8. While pressing the accelerator pedal, the following events should occur in exactly the order shown:
EVENT APPROXIMATE PEDAL TRAVEL
Park brake release 0°-4°
Solenoid activation 4°-8°
Carburetor throttle actuation 8°-12°
9. While holding the accelerator ball joint with pliers, tighten the jam nuts against the ball joints, accelerator ball joint
first, at each end of the accelerator rod.
10. Check rod adjustment for proper switch activation.
11. After the pedal group and accelerator rod are properly adjusted, adjust the engine RPM setting. See Engine
RPM Adjustment on page 17-11.
12. Install the electrical box cover and tighten retaining screw to 18 in-lb (2.0 N·m).
13. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
GOVERNOR CABLE
Governor Cable Removal
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Access the engine compartment.
3. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-3.
4. Disconnect the governor cable (2) at the carburetor throttle.
5. Disconnect the governor cable (2) from the governor lever arm (15) (Figure 17-9, Page 17-9) .
6. Remove the governor cable (2) from the governor cable engine bracket (11), and governor cable support bracket
(10)
(Figure 17-9, Page 17-9) . Remove the cable (2) from the vehicle.
Page 17-8 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual