background image

 

Wheel and Tire Installation

 

2001 Carryall 2 XRT Owner’s Manual Supplement        11

 

WHEEL AND TIRE INSTALLATION 

 

Unlike other Club Car Carryall vehicles, the Carryall 2 XRT’s front and rear wheels are NOT interchangeable.
The rear wheels have a different offset than do the front wheels; The rear wheels must be installed with the
deeper offset facing out. 

A rectangular sticker on each wheel designates its correct location on the vehicle.

LF —Left Front (driver side)

RF—Right Front (passenger side)

LR—Left Rear

RR—Right Rear

Standard Carryall 2 XRT tires (off-road) are directional and must be installed according to the directional arrow
mark on each tire, (arrow must indicate forward rotation of tire) or tread performance will be severely compro-
mised. The optional turf tire is not directional, and installation is dictated only by correct wheel position, not tire
direction.

1. Slightly loosen the lug nuts on all four wheels. 

2. Raise one end of the vehicle until the tires are off the ground by approximately six inches. 

 

See follow-

ing WARNING.   

 

3. Remove the lug nuts and the wheel.

4. Install the correct wheel and tire assembly and tighten lug nuts (using a crisscross pattern) until they

are snug. 

 

Arrow must indicate forward rotation of tire

 

.

5. Repeat steps 3 and 4 for the other side of the vehicle.

6. Lower the vehicle to the ground and finish tightening lug nuts (using a crisscross pattern) to 55 ft-lb.

(74.6 N·m).

7. Repeat steps 2-6 for the other end of the vehicle. 

 

• UPON VEHICLE DELIVERY, THE SHIPPING WHEEL AND TIRE ASSEMBLIES MUST BE REPLACED

BY THE STANDARD XRT WHEEL AND TIRE ASSEMBLIES, WHICH ARE DELIVERED IN THE
VEHICLE CARGO BED.

• DO NOT REMOVE THE WARNING TAG ATTACHED TO THE STEERING WHEEL UNTIL THE

SHIPPING WHEEL AND TIRE ASSEMBLIES HAVE BEEN REPLACED BY STANDARD XRT WHEEL
AND TIRE ASSEMBLIES.

• LIFT ONLY ONE END OF A VEHICLE AT A TIME. BEFORE LIFTING, SET THE PARK BRAKE WHEN

LIFTING THE FRONT OF THE VEHICLE , UNLOAD THE  CARGO BED, AND CHOCK THE WHEELS
THAT REMAIN ON THE FLOOR. USE A SUITABLE LIFTING DEVICE (CHAIN HOIST OR
HYDRAULIC FLOOR JACK) WITH 1000 LB. (454 KG) MINIMUM LIFTING CAPACITY. DO NOT USE
LIFTING DEVICE TO HOLD VEHICLE IN RAISED POSITION. ALWAYS USE APPROVED JACK
STANDS OF PROPER WEIGHT CAPACITY TO SUPPORT  VEHICLE.

NOTE

WARNING

Содержание CARRYALL 2 XRT













Отзывы: