Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 45 / 436

BODY AND TRIM Seat
4
WARNING
• Exceeding the maximum torque value could result in damage to the ROPS tubing and stripped threads
on the hardware.
• Ensure that the ROPS is properly installed before operating the vehicle.
SEAT
See General Warnings, Section 1, Page 1-2.
SEAT REMOVAL
1. Bucket seats
1.1. Lift the seat back up and forward to raise it.
1.2. Remove the seat by lifting the front edge hinges from the vehicle frame hinge slots.
2. Bench seat
2.1. Lift the seat bottom up and forward to raise it.
2.2. Remove the seat by lifting the front edge hinges from the vehicle frame hinge slots.
SEAT ADJUSTMENT
1. Stationary driver and passenger bucket seats
1.1. Remove the seat from the vehicle.
1.2. Remove the four bolts and washers from the bottom of the seat mounting plate.
1.3. Align the mounting plate holes with the holes in the seat to achieve the desired seat position.
1.4. Install the washers and bolts, and tighten the hardware to 80 in-lb (9.0 N·m).
1.5. Install the seat. See following WARNING.
WARNING
• Ensure that the seat hinges and latch are securely engaged before operating vehicle.
2. Track-mounted driver seat
2.1. Sit in seat, grasp seat adjustment handle under seat bottom and slide seat to desired position. See
preceding WARNING.
SEAT INSTALLATION
1. Align the hinges on the underside of the seat front edge with the hinge slots on the frame.
2. Bucket seats
2.1. Push back and down on the seat back to secure the seat latch to the frame. See preceding WARNING.
3. Bench seat
3.1. Hold center seatbelt buckles (if equipped) up and out of the way. Lower rear of seat to frame.
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual Page 4-9