Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 358 / 436

17
Transmission DRIVETRAIN COMPONENTS
FORWARD/REVERSE SHIFTER CABLE
See General Warnings, Section 1, Page 1-2.
Forward/Reverse Shifter Cable Removal
NOTE: Before the Forward/Reverse cable is removed, note the cable routing and the wire tie positions and the
positions of other devices securing the cable to the vehicle. When installed, the cable must be routed and
secured as it was originally.
1. Disconnect battery and spark plug wire(s) (gasoline vehicles only) . See Side-Post Battery: Disconnecting
the Battery – Gasoline/Diesel Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2. Raise the hood.
3. Disconnect cable end from Forward/Reverse shifter handle in the dash by removing clip (Figure 17-13, Page
17-11) .
4. Loosen the flanged nuts on the cable at the shifter handle bracket (Figure 17-13, Page 17-11) .
NOTE: Note the positions of the flanged nuts on the cable. The nut farthest from the handle should be at the farthest
end of the threaded portion of the cable.
5. Remove seat.
6. Note the positions of the wire ties that secure the cable between the dash and the transmission and then remove
the wire ties.
7. Disconnect cable end from transmission shifter arm by removing clip (Figure 17-13, Page 17-11)
8. Loosen the flanged nuts from the cable bracket that is below and forward of the transmission shifter arm (Figure
17-13, Page 17-11) . See following NOTE.
NOTE: Note the positions of the flanged nuts on the cable. This hardware will be used to adjust the handle position
during installation.
Secure a heavy nylon cord to the transmission end of the cable. Pull the cord and cable at the dash frame
from the transmission and allow the cord to travel under the body.
9. Remove the shifter cable.
Page 17-10 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual