Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 119 / 436

REAR SUSPENSION Trailing Arms and Lateral Links
9
TRAILING ARMS AND LATERAL LINKS
See General Warnings, Section 1, Page 1-2.
LATERAL LINK REMOVAL
1. Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery –
Gasoline/Diesel Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2. Lift and support the rear of vehicle and remove the wheel. See Lifting The Vehicle, Section 3, Page 3-7.
3. Support the rear axle.
4. Remove the hardware securing the lateral link (1) to the chassis (Figure 9-2, Page 9-4) .
5. Remove the hardware securing the lateral link (1) to the rear axle.
LATERAL LINK INSTALLATION
1. Installation is the reverse of removal (Figure 9-2, Page 9-4) . Orient hardware as shown.
2. Tighten hardware at each end of link to 57 ft-lb (77 N·m).
3. Install wheel and lower vehicle. See Wheel Installation on page 8-2.
4. Connect battery and spark plug wire(s). See Side-Post Battery: Connecting the Battery – Gasoline/Diesel
Vehicles on page 1-4.
See Top-Post Battery: Connecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
TRAILING ARM REMOVAL
See General Warnings on page 1-2.
1. Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery –
Gasoline/Diesel Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2. Raise the cargo bed. See Body and Trim, Section 4, Page 4-1.
3. Lift and support the rear of vehicle and remove the wheel. See Lifting The Vehicle, Section 3, Page 3-7.
4. Support the rear axle.
5. Remove the hardware securing the trailing arm (2) to the rear axle (Figure 9-2, Page 9-4) .
6. Remove the hardware securing the front of the trailing arm to the chassis and remove the trailing arm.
TRAILING ARM INSTALLATION
1. Installation is the reverse of removal (Figure 9-2, Page 9-4) . Orient hardware as shown. See following NOTE.
NOTE: Be sure the wear clip (3) is in place on chassis when trailing arm is installed and secured with hardware.
2. Tighten the trailing arm hardware to 57 ft-lb (77 N·m).
3. Install wheel and lower vehicle. See Wheel Installation on page 8-2.
4. Lower the cargo bed. See Body and Trim, Section 4, Page 4-1.
5. Connect battery and spark plug wire(s). See Side-Post Battery: Connecting the Battery – Gasoline/Diesel
Vehicles on page 1-4.
See Top-Post Battery: Connecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual Page 9-3