Club Car 2005 precendent, Техническое обслуживание и сервис, Страница: 48 / 256

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group
Page 5-6 2005 Precedent Gasoline Golf Car Maintenance and Service Manual
5
PEDAL GROUP INSTALLATION
1. Place the GCOR on the pedal group and secure with two screws (1) (Figure 5-3, Page 5-3) . Tighten the
screws to 23 in-lb (2.6 N·m).
2. Insert the end of the accelerator cable (10) into position on the pedal group (Figure 5-2, Page 5-2) .
3. Connect the wire harness (12) to the GCOR (11) (Figure 5-2, Page 5-2) .
NOTE: Connector will only fit together in one orientation.
4. Position the pedal group in vehicle and secure with two screws (2) on the driver side and two screws (1)
on the passenger side. Tighten driver side screws (2) to 12 ft-lb (16.3 N·m). Tighten passenger side
screws (1) to 5 ft-lb (6.8 N·m).
5. Use the turnbuckle (6) to connect the rod from the pedal group to the brake actuator rod. Ensure the ends
of the brake cables do not slip out of the brake equalizer during this procedure.
Figure 5-5 Accelerator Spring Clip Figure 5-6 Accelerator Spring Upper Crosspin
Figure 5-7 Accelerator Spring Pin Removal
1