Club Cannon MICRO JET MKII, Руководство пользователя

Страница: 12 / 20

ATTACH BARREL
Screw fitting of barrel to CO₂ outlet. Set desired angle of
jet, hand tightening to temporarly hold in place. Use either
a 11/16(17mm)
wrench or adjustible wrench to fully tighten
fitting securely.
1.
SET ADDRESSES
To expedite setup time, we have implimented single digit
addressing. Each set of arrows independantly controls the
above digit. While receiving DMX hold button to unlock first.
Note: Only 1 channel triggering is availible on this unit.
3.
ATTACH HOSE
Follow the steps outlined on CO₂ SETUP GUIDE for proper
CO₂ setup.
Read through the entire manual for more in-depth information,
including safety procedures and best practices.
5.
BOOT MICRO JET MKII
The Micro Jet MKII accepts AC power through the TRUE1
connector on the rear of the product. Verify correct supply
voltage prior to use. Incorrect voltage may cause damage to
unit. Rated voltage is marked above the power inlet.
2.
CONNECT DMX
The last step is to attach a DMX controller like “The Button” or
“ShoMaster” to control the Micro Jet MKII.
4.
QUICK START DMX GUIDE
10