www.cls-led.com
www.cls-led.com
6
5
LENS REPLACEMENT
2
4
Glass
Front plate
Lensholder
1
3
4x
Secure in
order
1
2
3
4
T20
Glass
Front plate
Lensholder
Make sure that
the items are clean
and the rubber
sealing is correctly
in place!
T20
1
2
3
To get the
desired intensity
level, hold the
magnet
on the REVO
4
Place the
magnet
at the indicated
‘bullseye’ on the
backplate
#Y106015
1. Place the magnet on the backplate, at the indicated spot.
2. The REVO starts slowly dimming from 100 – 1% in approx. 30 seconds.
The dimming is very accurate and precise, so steps are very small.
3. At the desired intensity level, take away the magnet.
4. After 10 seconds the REVO flashes one time, the value has been stored on the internal memory.
5. When powering up the REVO, the stored value will be recalled from the internal memory.
6. If you want to have a lower value, replace the magnet and the REVO dims further to lower levels.
To store the new setting repeat step 3 – 5.
7. If the REVO is being dimmed to Level 0 and you have not programmed a value, it will automatically
start at Level 100 and dim back from 100 - 1%.
MAGNO DIMMING
2017 CLS-LED BV. All rights reserved. Information subject to change without notice, CLS-LED BV and all affiliated companies
disclaim liability for injury, damage direct or indirect loss, consequential or economic loss or any other loss occasioned
by the use of, inability to use or reliance on the information contained in this manual. No part of this manual may be
reproduced, in any form or by any means, without permission in writing from CLS-LED BV. Other legal information can be
found in our General conditions,found on the back of your CLS-LED BV invoice, inside the CLS catalogue or on our website
www.cls-led.com/General-Terms.pdf
