CLS Facade 12 RGB, Руководство пользователя

Страница: 2 / 4

CLS Manuals
CLS Atmosphere LED-panel
www.cls-led.com www.cls-led.com
- 3 - - 4 -
CLS Manuals
CLS Façade 12 RGB
Protection from injury due to falls
• Verify that all covers and mounting hardware is securely fastened.
• Block the access around the work area whenever installing or removing the unit.
INSTALLATION
This section describes in general terms how to connect the CLS Façade 12 RGB.
Connecting the CLS RGB Façade to a DMX driver
You need a driver to control the CLS RGB Façade. Use only a CLS driver which is compatible with the CLS Façade
12 RGB. With the CLS DMX-1000 you can connect the CLS Façade 12 RGB simple and fast.
Before installing ensure that you have the right products. For a correct installation you need:
DMX-1000
2 CLS Façade 12 RGBs
1 CLS DMX-1000
1 CLS connection cable between DMX-1000 and CLS Luxeon RGB products
1 DMX controller (optional)
!
W
ARNING
ATTENTION!
CONNECT AT lEAsT 2 ANd A mAxImum Of 3 Cls fAçAdE 12 RGB
ON ONE Cls dmx-1000.
!
W
ARNING
ATTENTION!
WhEN yOu usE ThE Cls RGB fAçAdE OuTdOOR, plEAsE usE ThE
Cls mOld sET fOR ThE xlR 7 pOlE CONNECTORs, TO mAkE ThEsE
CONNECTORs AlsO Ip65.
Protection from burns and fire
• Do not install the CLS Façade 12 RGB near a heat source.
• Do not install the CLS Façade 12 RGB in a corrosive, flammable or explosive area.
• Do not modify the CLS Façade 12 RGB, or install other than genuine parts.
• Do not operate the CLS Façade 12 RGB if the ambient temperature exceeds 40º C.
ATTENTION!
ThE fAçAdE 12 RGB Is AN Ip65 OuTdOOR uNIT, BuT uNdER
NO CIRCumsTANCEs CAN BE usEd uNdER WATER!
W
ARNING
The CLS Façade 12 RGB can be installed
by using the mounting hole. Drill a hole to
secure it in the wall, floor ceiling, etc.
Drill 2 holes for the DMX cables.
Adjust the CLS Façade 12 RGB to the
preferred position by turning the unit
towards or away from the wall.
Put the power wire of the DMX driver
in the earthed socket. The CLS Façade 12 RGB is ready to
use.
Mounting