www.cls-led.com
CLS Colour Par 12
- 10 -
- 3 -
maiNtENaNcE
Make sure fixture is cool and disconnected from power mains before any service.
Weekly operating hours and environmental conditions will establish how often the fixtures need cleaning.
Fixtures should be cleaned and inspected at least once a month to maintain optimum performance.
Accumulation of dust and fog residue increases heat build up, can lead to malfunctions, overheating and
reduction in maximum light output, reduced fixture life and over all performance. Before conducting any
maintenance, disconnect fixture from power mains.
• Disconnect fixture from power mains.
• Use a vacuum with a soft brush to remove dust collected on external vents and internal components.
If using an air compressor, use low pressures and extreme care to prevent damaging any internal parts or
effects. 3) Clean all optical elements when the fixture is cold. Use a soft lint free cotton cloth or tissue and
cleaner safe for plastics.
• Inspect clamps and safety cables to ensure fixture is secure and safe.
troubLEshootiNg
symptom
possible causes/solutions
No Power
Check for power on mains
Check main fuse and fuse holder
Erratic / No response to DMX
Check data cables: connection and proper wiring
Check Display settings
Check Start Address
Check Master/slave settings
Incorrectly responds to
DMX Check Start Address
(Diagnostic technique for DMX issues:
Check Start Address
Set suspect fixture’s Start Address the same as a
Check for overlapping addresses
correctly functioning fixture. If both units then
Check Menu settings
function correctly, issue is programming)
Check Data cables (faults and proper wiring)
Note: It is important to read this manual before you install this product.
iNtroDuctioN
Thank you for selecting the CLS Colour Par 12 with 512 DMX-channels. The CLS Colour Par 12 is a universal
DMX controlled luminairy that uses 12 Tricolor LEDs to create an even light-output.
the cLs colour par 12 features:
• 100 ~ 240 VAC input
• Tricolor RGB colour mixing with intensity and strobe effects
• Precise DMX control using 6 channels
• Stand alone or DMX 512 controllable
• Dual joke for floor or mounting
• Indoor use only
included items
The CLS Colour Par 12 is shipped in one package containing the following items:
• 1 CLS Colour Par 12
• 1 user manual
optional accessories
• 707028
CLS Zense DMX cont built in 4 amp RGB dimmer
• 707030
CLS ACX60 DMX controller for max. 60 channels
• 875580
CLS PAR RGB DMX controller
• 911200
CLS Extension cable black XLR male/female 80cm
• 911201
CLS Extension cable black XLR male/female 1.5mtr
• 911203
CLS Extension cable black XLR male/female 3mtr
• 911205
CLS Extension cable black XLR male/female 5mtr
• 911206
CLS Extension cable black XLR male/female 10mtr
• 911207
CLS Extension cable black XLR male/female 15mtr
• 911209
CLS Extension cable black XLR male/female 20mtr
available colour par 12
• 875590
CLS Colour Par 12, Tricolor-LED DMX 50W 100-240VAC
safEty iNformatioN
Warning! this product is for professional use only. read this manual before powering up or
installing the cLs colour par 12. follow the instructions listed below and observe all
warnings in this manual.
