Clover TH82, Справочное руководство

Страница: 58 / 68

TH82 Series Reference Manual
58/58
*If the width set for the printing area is less than one line in horizontal, the following is processed
only on the line in question when bit image is developed.
① The printing area width is extended to the right to accommodate one line in horizontal
for the bit image within the printable area.
②
If the printing area width cannot be extended sufficiently by executing
①
, the left
margin is reduced to accommodate on line in horizontal.
*The commands which execute the printing area width for bit image and its minimum width are as
follows.
*Bit image (
ESC *
): Single density mode =2 dots/Double density mode =1dot
*Download bit image (
GS /
): Double width or Quadruple mode = 2 dots
Normal or Double height mode = 1 dot
*NV bit image mode (
FS p
): Double width or Quadruple mode = 2 dots
Normal or Double height mode = 1dot
*Raster bit image (
GS v 0
): Double width or Quadruple = 2 dots
Normal or Double height mode = 1 dot
[DEFAULT]
nL = 64
、
nH = 2 (576)
GS
╲
Set relative vertical printing position in page mode
[FORMAT]
<1D>H<5C>H<nL><nH>
[RANGE]
0 ≦ nL ≦ 255
0 ≦ nH ≦ 255
[FUNCTION]
Sets relative vertical print starting position from the current position in page mode. The distance is
set from the current position to [(nL + nH x 256) x vertical or horizontal motion unit].
[DETAILES]
*This command is ignored except when page mode is selected.
*When pitch N is specified to the movement download (positive direction):
nL +nH x 256
When pitch N is specified to the movement upward (negative direction), use the complement of
65536. :
*When pitch N is specified to the movement upward.
nL +nH x 256 = 65536 - N
*Any setting exceeds the specified printing area is ignored.
*The following commands are enabled depending on the starting position set by
ESC T.
① When the starting position is specified to the upper left or lower right of the printing,
the vertical motion unit (
y
) is used
②
When the starting position is specified to the upper right or lower left of the printing,
the horizontal motion unit
(x
) is used.
*The horizontal and vertical motion units are specified by
GS P
.
*The calculated result is truncated to the minimum value of the mechanical pitch.