Cloos QINEO, Руководство по эксплуатации, Страница: 104 / 186

104
MAIN (2) - Data backup
13.2 Read job from SD memory card
All jobs on the SD memory card are displayed.
Read in a single job
Use rotary knob 3 to select the job to be saved and confirm the selection by
pressing rotary knob 3 (Enter function). The job is saved in the job memory
of the welding power source.
Read in several jobs (Block)
Use the function "from Job" to select the beginning of the block, e. g. Job 1.
The display shows "Block Start" and the selected job number in yellow. Now
select by means of rotary knob 3 the end of the block, e. g. job 7 and press
the function "to Job".
Press rotary knob 3 to save the marked block in the job memory of the
welding power source.
13.3 Copy characteristic curve to SD card
This menu provides 2 functions.
Syn > Card
After activating the function, the current characteristic curve is saved on
the SD memory card.
DSA > Card
After activating the function, the current data set number is saved on the
SD memory card.
13.4 Read characteristic curve from SD memory card
After activating the function, all characteristic curves on the SD memory
card are shown on the display. You can select a characteristic curve by
turning rotary knob 3 or via the arrow keys. By pressing the rotary knob,
the selected characteristic curve is loaded into the memory of the welding
power source.
13.5 Copy configuration data to SD memory card
Shows all existing configuration files. Only saves the existing files (green
tick).
13.6 Read configuration data from SD memory card
The content of the SD memory card is displayed. You can only select and
transfer individual files.
An error message will appear if no SD memory card is available in the card
slot.
INFO!