Cloos NexT 452 AC, Руководство по эксплуатации

Страница: 62 / 234

62
MAIN (2) - Config (Configuration)
9.1.4 Config - General - Basic settings
In this menu, the basic settings for the use of the welding power source are
made.
Start/End program in 2-cycle mode
Designation Function
"Off"
For welding applications it is often not required to use
start and end crater programs (e.g. frequent spot weld-
ing). Therefore, you have the option to switch off this
function. This modification becomes only effective when
the characteristic curve is called up again.
"On"
External control
• Number of control voltages (is ignored in connection with QTI)
Designation Function
"0"
• If the robot shall only set the job number, but no other
parameters.
"2"
• If the robot shall set the two parameters “Arc length”
and “Power”.
"3"
• If the robot shall set the three parameters “Arc length”,
“Power” and “Dynamics”.
• External process selection (is ignored in connection with QTI)
Designation Function
"Off"
• If two different processes are executed at the same
time with a Tandem torch.
• If variants of synergy characteristic curves are used.
• If a correction value for Upslope or Downslope was set
and the robot changes the process during operation.
The correction value is also taken over for the following
process! If you do not want this behaviour, we recom-
mend to change the process via a job change.
"On" • If the robot shall pre-set the welding process.
Display Konfig, Grundeinstellung NexT
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Konfig - Grundeinstellungen
Externe Ansteuerung
Anzahl Leitspannungen 3
Ext. Prozessanwahl Aus
Qirox Parameter Ein
Start-/Endprogramm im 2 Takt
Start-/Endeprogramm Aus
Feinabgleich-Variante
Feinabgleich über Kennlinie
Tandem
Auf
Werksein-
stellungen
zurück
Figure 31. "Config" - "Basic settings" menu