Cloos NexT 452 AC, Руководство по эксплуатации

Страница: 120 / 234

120
Description of the additional functions
3.7 Functions - Loading Saving
USB stick in FAT32 format plugged
into the back of the welding
power source.
SD memory card in the operating module
board or optionally USB stick in FAT32 format
in the USB connection on the operating
module.
Save / load job
1. Turn the rotary knob to select a job.
2. Press the rotary knob to mark a job. The marked job is the start position
for the selection of further jobs which are adjacent to this position.
3. If necessary, turn the rotary knob a second time to determine the end
position of the selection.
4. Press the rotary knob to transfer the marked jobs.
• The jobs within the selection zone are saved externally or loaded into
the memory of the welding power source.
Save characteristic curve
After activating the function, the current characteristic curve is saved on
the external storage medium.
The "DSA" function saves the data set number of the characteristic curve
data set in the "Synergie.syn" file on the external storage medium.
Load characteristic curve
1. Select a characteristic curve using the rotary knob.
2. Press on the rotary knob to confirm your selection.
• By pressing the rotary knob, the selected characteristic curve is loaded
into the memory of the welding power source.
Save configurations
This menu shows all configurations which can be transferred.
Only the configurations are transferred for which the corresponding
hardware is available at the welding power source. Example: If the welding
power source has an SD module, the "SDMODUL.CFG" configuration file is
saved.
After a successful saving, the corresponding configuration file is marked
with a green tick. If a file was skipped, a white line appears at the respec-
tive position. If a file could not be transferred, a red X line appears at the
respective position.
Load configurations
You can only select and transfer one file.