Clockaudio CCRM 4000, Инструкция по установке и эксплуатации

Страница: 26 / 32

Page 20 of 25 V2.1 2021-01
6.3 IR Remote Control Additional Information
 When programming an incorrect address ID code, for example 32, and that address ID does
not exist, it will just be ignored / nothing will happen when either the up-arrow or down-
arrow keys are pressed. Wait 5 seconds and re-enter the correct address code.

While initially programming the cable height, the Up and Down buttons work on a press and
hold basis. The microphone will continue to move either up or down all the time the button
is pressed. The cable will stop when either button is released.

If there is a pause of longer than 5 seconds between button presses before the ENTER
button is pressed, the sequence will need to be restarted from the beginning. Once the
green programme LED is lit there is no time-out limit.

A green LED will be lit on the IR sensor to indicate that programme mode has been entered.
The LED will extinguish upon exiting the programme mode (press Enter). Thereafter each
time a remote button is pressed a red LED will flash indicating the transmitter is in range and
a command has been received.

IR range is approximately 7.5M (25 feet).
 Deployment of the microphone can be done using either the IR Remote or the DSP.
However, whatever method is used to deploy the microphone, the same method must be
used to retract it. For instance, trying to retract a microphone using the IR Remote if it had
been deployed via a DSP will not work. Same case if the microphone was deployed using the
IR remote, it cannot be retracted using the DSP. Only use one method to deploy or retract.
6.4 Programming Cable Height on Main Unit
The remote control is used to set up the cable height and can also be used to deploy and retract the
microphone. For a single unit installation (Main) the default factory setting is set to 00.

Point the remote at the IR receiver and press 00 followed by the ENTER button (green LED
will light on the IR sensor showing it’s in programme mode). Press the Up / Down buttons on
the remote. Set the correct height of the microphone. Press the ENTER button to store this
height position into the memory (green LED will go out). Immediately afterwards the
microphone will retract to the ceiling bezel to confirm that the operation has been
successful.

Test by briefly pressing the Down button on the remote and the microphone will move
down and stop at the programmed height. Press the Up button and the microphone will
retract back up to the Bezel. If an incorrect height has been programmed then repeat the
above instructions.