CLIMTEC RD Series, Технический паспорт

Страница: 40 / 44

40
1. Disconnect the power supply.
2. Remove the decorative sleeve (photo 1).
3. Disconnect the supply cable terminal blocks (photo 2).
4. Hold the pipe and pull out the working module (photo 3, 4).
5. IT IS PROHIBITED TO PULL THIS WAY (photo 5).
6. Change the filter (photo 6).
7. Follow in reverse order. We install the module into the pipe (photo 7).
8. IT IS FORBIDDEN TO INSTALL THE MODULE IN THE PIPE! (as show on photo 8).
1. Follow steps 1-4 of the previous instruction above.
2. Connect the power cable terminals to the working module, turn on the power, turn on the
recuperator from the remote control.
3. In order to keep the automatic air flow shut-off valve open, it is necessary to disconnect the
power cable terminals from the operating recuperator. It is impossible to disconnect from the
control unit, because the automatic air flow shut-off valve will close.
4. Recuperator cleaning: take the module, blow out the module with compressed air at a pressure
of no more than 4 bar, remove dust from the fans.
5. Install the module back into the pipe.
6. Connect the terminals of the supply wire.
7. Connect to the network.
8. When power is restored, the automatic air flow shutoff valve will return to its original position
(closed).
MAINTENANCE
HEAT EXCHANGER CLEANING:
FILTER REPLACEMENT:
photo 1
photo 5
photo 2
photo 6
photo 3
photo 7
photo 4
photo 8