Climote HUB, Руководство по установке, Страница: 6 / 16

6
Commission climote HUB (7)
1. Navigate to Zone Setup
Using the Menu/Back button and Scroll Wheel,
select :
1.
Menu.
4. Commission Device.
2. Settings.
5. Zone Setup.
3.
Installer Settings.
2. Set up Zones
1. Active zones – On or Off. Set One, two or three
zones to “On” to match the zone configuration.
Turn scroll wheel to change, push to select, then
select “Next”.
2. Thermostat Settings (see Thermostat Options)
Turn scroll wheel to change, push to select, finally
select “Next”.
3. Select Save – this communicates the settings to
climote ONLINE.
Carry Out Local Checks (6)
Local checks
1. Check unit shows correct time within 1 minute
of completing start-up sequence. If time does
not update, follow steps for “time” in
Diagnostics (12).
2. Press the Menu/Back button. Observe Menu
Options are displayed. Choose Settings, Signal
Strength. Note signal strength.
3. If signal strength is less than 25% follow steps
for “poor signal” in Diagnostics (12).
4. Press Menu/Back 3 times to exit.
5. Press “Boost” button for Living zone. Boost
menu is displayed, select Boost for 1 hour.
Observe Boost light glows orange and heating
is turned on in living zone.
6. Press Living Boost again and select Cancel
Boost. Boost light is extinguished and heating
is turned off in living zone.
7. Repeat for all active zones.