Climax VST-2735 Series, Руководство пользователя, Страница: 27 / 60

24
4. Operation
4.1. LCD Display
The Control Panel’s LCD will display the
system information according to different status
and panel modes.

Disarm mode
When the system is in Disarm mode, and no
fault exists in system, the LCD will display
―Ready to Arm‖.
R e a d y t o A r m
0 0 : 0 1 J a n 0 1
When fault events exists in system, The LCD
will display the fault event on screen, followed
by ―(
XX )‖. The XX represents the number of
fault event in system.
When Control Panel or accessory tamper open
status is detected, the LCD will display
―Tamper Zone‖
T a m p e r Z o n e ( X X )
0 0 : 0 1 J a n 0 1
When Door Contact in the system is opened
(not aligned with magnet), the LCD will display
―Open Zone‖
O p e n Z o n e ( X X )
0 0 : 0 1 J a n 0 1
When other fault exists in system, the LCD will
display ―Fault‖
F a u l t ( X X )
0 0 : 0 1 J a n 0 1

Away Arm / Home Arm mode
When the system is in Away Arm or Home Arm
mode, and no fault event exists in system, the
LCD will display current mode.
A w a y A r m
0 0 : 0 1 J a n 0 1
When the system is in Away Arm or Home Arm
mode, and fault event exists in system, the
LCD will display (
XX ) after current mode. The
XX represents the number of fault event in
system.
A w a y A r m ( X X )
0 0 : 0 1 J a n 0 1

View Fault Events
When fault event exists in system, press Down
key to view fault events.
Step 1. The screen will display:
S T A R T

Step 2. Press Down key to scroll through the
fault events. When all fault events are
displayed, the screen will show:

E N D
Step 3. Press key to exit fault display.
4.2. Entering User Menu
When the system is in Disarm mode, enter a
valid user code to access the User Menu,
When the first numberic key is pressed, the
display will show:
E n t e r C o d e
 . . . .
Enter the 4-digit user PIN code followed by
OK , within 30 sec.
The options are available for user menu:
o F a u l t D i s p l a y
L o g
A l a r m M e m o r y
B y p a s s
A p p l y S c e n e
A w a y A r m
H o m e A r m
P - M e n u
I - M e n u
<NOTE>

If you wish to arm the system when
fault event exists, please refer to
section Forced Arming below.
4.3. Away Arm Mode
The Away Arm Mode will arm all divice in the
Control Panel to react accordingly upon alarm
trigger

Entering Away Arm mode
Step 1:

Select Away Arm under User Menu
and press OK .

When under Disarm mode, enter a
User PIN code and press the
Away
Arm key on the Control Panel.

When under Disarm mode, enter a