Climax Vesta ESGW Series, Руководство по установке

Страница: 7 / 71

4
3. Getting Started
Read this section of the manual to learn how to set up your ESGW series Control Panel and
program System Settings over the Web page.
3.1. System Deployment
The Control Panel is designed to be placed on desktop, follow guidelines below when planning
installation location:

The Control Panel requires Ethernet connection for system programming, alarm reporting
and remote control.

The Control Panel should be installed at a location that is hidden from outside view.

The Control Panel should be protected by sensors so that no intruder can reach the Control
Panel without activating first activating sensor.
3.2. Installing the Control Panel
Step 1. For configuration and operation of Control Panel via Ethernet, connect the IP cable to
the RJ-45 connector.
Step 2. Connect the Power Adaptor to a Wall Outlet and the other end to the Control Panel.
After several seconds, the System Mode Blue LED will turn on to indicate system is
now functional.
Step 3. The Control Panel can be mounted on wall with its wall mounting holes. Use the two
holes to mark location on the wall, drill holes into wall and install screw at mounting
location, then hang the Control Panel onto the screws.
3.3. Software Installation
※
THIS INSTALLATION IS ONLY REQUIRED FOR FIRST TIME USER
※
1. RUNNING THE FINDER SOFTWARE
The Finder software is required for your computer to identify the control panel on the LAN.
Step 1. To download Finder software, o
pen your browser and type below URL in the
address bar: http://www.climax.com.tw/climax-download-finder.html .