27
5. Local RF Device Management
VCP-LTE can learn up to
20
RF devices which can be used to activate VCP-LTE to
make emergency report.
Entering Learning Mode
Press the Alarm Button of VCP-LTE for 8 seconds. VCP-LTE will emit one beep at the
8
th
second. Release the button after the beep at 8
th
second to enter learning mode.
Device Learning and Testing
Step 1.
Press the Button on RF device to transmit signal. Refer to RF device manual for
detail.
Step 2.
VCP-LTE will emit 2 beeps when it receives the signal from the pendant to
indicate it has learned in the pendant.
Step 3.
Repeat Step 2~3 to learn in all devices, device learnt in will be assign from Zone
1 to 20 in sequence.
If VCP-LTE has already learnt in 20 devices, it will emit 3 beeps upon receiving
a new device learn code to indicate error.
To test learnt in device, press the device button again after learning, VCP-LTE
will emit a long beep if it successfully receives signal from already learnt in
device.
After complete learning, press the Alarm Button on VCP-LTE once to exit
learning mode. VCP-LTE will emit 2 beeps
Device Removal
Press VCP-LTE Alarm Button twice quickly under learning mode, VCP-LTE will emit two
beeps to indicate ALL RF devices have been removed and exit learn mode
automatically.