Climax Coffee Grinder
Made In Melbourne Australia For Over 65 Years
5. Replacing grinding discs
Before changing grinding burrs switch off the motor and pull the power cable out of its
socket.
Grinding burrs must only be replaced by persons familiar with operation of the machine
according to the following instructions.
-
Switch off (L025) the motor and pull out the power cable.
-
Dismantle top cover (L002), 2 screws on each side use 2.5mm hex key.
-
Remove selection knob (L014), place two levers under the grind selection knob,
pull gently large black knob will slide off its serrations.
-
Remove front cover (L009), 2 screws top and bottom inside cover, main body
side, use 2.5mm hex key.
-
Remove setting nut (L013) unwind anti clockwise until removed.
-
Remove tension spring screw (L015), use 5mm hex key.
-
Remove tension spring (L016), slide out one side then the other side.
-
Remove Hopper (L007), 2 screws centrally located use 2.5mm hex key.
-
Remove agitator spring (L012), 1 screw centrally located at top of cutter housing
(L023) chamber, use 3mm hex key.
-
Pull out stationary cutter hub (L017) remove burr, 3 screws use 5mm hex key.
Clean thoroughly as any dirt under the cutter could affect the quality of the grind.
Place new burrs in position and screw in place.
-
Remove Burr (L011) from rotating cutter hub (L010), 3 screws use 5mm hex
key. Clean thoroughly as any dirt under the cutter could affect the quality of the
grind. Place new burrs in position and screw in place.
-
Then re-assemble parts in reverse sequence. Tighten all screws.
-
Plug in power cable, switch on coffee grinder briefly. If it blocks or there is the
sound of metal parts rubbing together, disassemble and check.
-
Setting must be re-adjusted as per 4 Basic Calibration.
The CLIMAX
COFFEE GRINDER
is a precision machine, if the above instructions are
adhered to, we are confident that it will give many years of trouble free service.
