Climax H&S BOILER GUN BG22, Руководство по эксплуатации, Страница: 35 / 94

P/N 100241, Rev. 1 Page 23
2. Set the oiler valve to ‘3’ as a baseline for the
flow rate.
3. Replace the cap.
4. Mount and setup the machine (see Section 3.2-
3.5)
5. Squeeze and hold the throttle lever to run the
machine.
6. Hold a sheet of white paper approximately 4”
(101mm) in front of the exhaust ports on the
pneumatic motor. If adjusted correctly, there
will be a light splatter of oil on the paper after
a few seconds of operation.
7. If the oil rate needs adjusted, disconnect the
air supply line from the air filter end of the air
hose assembly.
8. Repeat Step 1.
9. The larger the number on the oiler valve the
higher the oil flow rate. Adjust as required.
10. Replace the cap and retest the machine for cor-
rected oil flow rate.
5.3.4 Tool holders
Do the following to service the tool holders:
1. Monitor and replace as necessary, the o-rings on
the I.D. of the tool holder.
2. Monitor and replace as necessary, the key stock
between the main gear and the tool holders.
5.3.5 Greasing the drive and pinion
gears
Do the following to grease the drive and pinion gears:
1. On either drive type, remove the four screws in
the gearbox adapter.
2. Slide the entire motor, gearbox and gearbox
adapter out of the machine housing.
3. Both the drive and pinions gears are now acces-
sible to be greased.
4. Reverse steps 1 and 2 to reassemble.
5.4 T
ROUBLESHOOTING
This section is intended to help you solve basic machine
performance problems. For serious maintenance or if
you have questions on the following procedures, contact
H&S.
5.4.1 The machine isn’t turning
If the machine is not rotating, check the following:
1. The air supply line is connected and sufficient
air pressure is present (pneumatic motor only).
2. The power source is connected and energized
(electric motor only).
3. The battery in the cordless electric machine is
charged.
5.4.2 The machine isn’t feeding
If the machine isn’t feeding properly, check the follow-
ing:
1. The center shaft is properly installed in the
machine and .50” (12.7mm) projects through
the back of the feed wrench.
2. The feed wrench is being turned in the wrong
direction.
3. The center shaft has been fed too far into the
machine and need retracted so .50” (12.7mm)
projects through the back of the feed wrench.
5.4.3 The machine is performing poorly
If the machine is performing poorly, check the follow-
ing:
1. The cutting tool is installed correctly.
2. That the set screw on the tool holder is tight to
the center shaft.
3. The machine is tight to the workpiece.
4. The cutting tool or insert is sharp and has the
correct geometry for the material and type of
cut.
5. Electric motor:
a) The feed direction is set to forward.
b) The battery is charged, cordless model
only.
6. Pneumatic motor:
a) There is oil in the in-line oiler.
b) The air supply to the machine is sufficient
in both quantity and pressure. Optimal
levels are: 90PSI at 38CFM.