Climax H&S BOILER GUN BG22, Руководство по эксплуатации, Страница: 34 / 94

Page 22 BG22 Boiler Gun Operating Manual
CAUTION
Avoid damage, premature machine wear,
and protect your warranty by using only
approved lubricants.
5.3 M
AINTENANCE TASKS
Maintenance tasks are described in the following sec-
tions.
5.3.1 Checking and filling the in-line
oiler reservoir
Do the following to check and fill the in-line oiler:
1. Check sight glass on the oil reservoir for the
presence of oil.
2. To refill: Remove the cap, fill the reservoir and
replace the cap.
F
IGURE
5-1. I
N
-
LINE OILER SIGHT GLASS
5.3.2 Servicing the filter element
See Figure A-10.
Do the following to service the filter element:
1. Remove the filter nut to access the filter ele-
ment.
2. Slide the filter element out of the filter hous-
ing.
3. Clean the filter element with a solvent and
compressed air.
4. Reassemble the filter and replace the filter nut.
5.3.3 Adjusting the oil flow rate of the
in-line oiler
WARNING
To adjust the oil flow rate the machine must
be mounted as if being used. ALL operating
and safety precautions must be taken to
avoid injuries.
Different lubricants and environments may effect the
rate of the in-line oiler.
Do the following to adjust the oil flow rate:
1. Remove the cap and check the oil level. Refill as
needed.
T
ABLE
5-2. A
PPROVED LUBRICANTS
Application Area Lubricant
Biodegradable Lubri-
cant
Viscosity (cSt) Quantity Frequency
Threads of the cen-
ter shaft WD-40 or light-
weight spray lube
N/A
Light coating
applied by
spray
Daily during machine
use
In-line oiler
MOBIL ALMO 525 or
10W SAE oil
N/A 46 @ 40C
Fill oil lubrica-
tor body
Each use
Unpainted Surfaces LPS1 or LPS2 N/A 38 @ 25C As required
Each use, and before
storage
Drive and pinion
gears
NOOK PAG-1 grease N/A 113 @ 100C
Light coating
applied by hand Weekly during machine
use