Climax H&S BOILER GUN BG22, Руководство по эксплуатации, Страница: 29 / 94

P/N 100241, Rev. 1 Page 17
WARNING
Check that the mounting system has been
fully tightened. After the machine has made
2-3 revolutions during operation, recheck
the mounting system for tightness in the
workpiece. If loose, the machine itself
could rotate causing severe injury to the
operator.
3.4 I
NSTALLING THE CUTTING TOOLS
Do the following to install the cutting bit(s):
1. Advance the tool holder towards the workpiece
to help with alignment of the cutting bit(s).
2. Loosen the set screws in the blade locks.
3. Slide the cutting bit into the channel with the
beveled cutting edge facing the direction of
rotation.
4. Align the cutting edge of the tool to cut the full
width of the workpiece wall.
5. Tighten the set screw(s) to secure the cutting
bit(s) to the tool holder.
T
IP
:
While the BG22 Boiler Gun can be
operated with one blade. Smoother
operation on harder materials or thicker
pipe walls will result with the use of
two blades.
F
IGURE
3-8. S
LIDING TOOL HOLDER
F
IGURE
3-9. C
UTTING BIT INSTALLED