Climax H&S BOILER GUN BG22, Руководство по эксплуатации, Страница: 14 / 94

Page 2 BG22 Boiler Gun Operating Manual
1.3 G
ENERAL SAFETY PRECAUTIONS
H&S leads the way in promoting the safe use of portable
machine tools. Safety is a joint effort. You, the end
user, must do your part by being aware of your work
environment and closely following the operating proce-
dures and safety precautions contained in this manual,
as well as your employer’s safety guidelines.
Observe the following safety precautions when operat-
ing or working around the machine.
Training – Before operating this or any machine
tool, you should receive instruction from a qual-
ified trainer. Contact H&S for machine-specific
training information.
Risk assessment – Working with and around this
machine poses risks to your safety. You, the end
user, are responsible for conducting a risk
assessment of each job site before setting up
and operating this machine.
Intended use – Use this machine in accordance with
the instructions and precautions in this manual.
Do not use this machine for any purpose other
than its intended use as described in this man-
ual.
Personal protective equipment – Always wear
appropriate personal protective gear when
operating this or any other machine tool.
Flame-resistant clothing with long sleeves and
legs is recommended when operating the
machine. Hot chips from the workpiece may
burn or cut bare skin.
Work area – Keep the work area around the
machine clear of clutter. Restrain cords and
hoses connected to the machine. Keep other
cords and hoses away from the work area.
Lifting – Many H&S machine components are very
heavy. Whenever possible, lift the machine or
its components using proper hoisting equipment
and rigging. Always use designated lifting points
on the machine. Follow lifting instructions in
the setup procedures of this manual.
Lock-out/tag-out – Lock-out and tag-out the
machine before performing maintenance.
Moving parts – H&S machines have numerous
exposed moving parts and interfaces that can
cause severe impact, pinching, cutting, and
other injuries. Except for stationary operating
controls, avoid contact with moving parts by
hands or tools during machine operation.
Remove gloves and secure hair, clothing, jew-
elry, and pocket items to prevent them from
becoming entangled in moving parts.
Sharp edges – Cutting tools and workpieces have
sharp edges that can easily cut skin. Wear pro-
tective gloves and exercise caution when han-
dling a cutting tool or workpiece.
Hot surfaces – During operation, motors, pumps,
HPUs, and cutting tools can generate enough
heat to cause severe burns. Pay attention to hot
surface labels, and avoid contact with bare skin
until the machine has cooled.