RS-232 GatewayPro
(CL-DR-GWP)
Rail Mounting
RS-232 GatewayPro is designed to be installed on a standard
35 mm wide DIN rail (EN 50022, BS 5584).
Hook the module from the top, pull down the rail moun ng
clips, push the module to the rail and release the rail
moun ng clips.
Screw Mounting
Screw the module to any surface through 4 corner screw
holes.
3
4
1
2
INSTALLATION GUIDE
version 1.0.7
Compatible with Control4
Compatible with Control4 USA
1
1
1
10
9
5
5
8
7
6
2
3
4
1
1. Screw holes
2. Power connectors
3. Contact input connector
(sensor)
4. Output connectors
5. Rail moun ng clips
6. Channel LEDs
7. Status LEDs
8. Control bu ons (1-8)
9. RS-232 jack
10. RS-485 jack
Compatible with Control4
Compatible with Control4 USA
#2
#3
#4
#5
#8
#1
#6
#7
#2
#3
#4
#5
#8
#1
#6
#7
Input Voltage
Input Current
I/O Connec ons
12V-24V DC (24V DC is recommended)
210mA (for 24V DC)
C-Bus
Output
1 X RJ45
Pr
oduc
t Spe
cific
a
on
RS-232
1 X RJ45
Input
8 relay channel-8A per channel
X
(rising-cage 5mm screw terminals)
1 digital dry contact input
X
(rising-cage 5mm screw terminals)
1
2
3
Enable/disable Autosave
If autosave func on is ac vated, reconnec ng main power will set all outputs to the last status
(before power outage).
In order to enable/disable autosave follow steps below consecu vely and uninterruptedly:
1.
Disconnect the main power. Hold bu on #1 & #2 simultaneously (bu on’s and LED’s number
sequence is considered from right to le as shown in following picture)
.
2.
Reconnect the main power. Release bu on #2 a er LEDs #1 to #4 flashed. Then release bu on #1
a er LEDs #1 and #2 flashed. Power LED will start flashing quickly.
3.
Press bu on #2, 4 mes.
4.
To disable/enable autosave mode, press bu on #1. LED #1 will display whether autosave mode is
disabled or enabled. If it is “on” the autosave mode is enable.
5.
Press bu on #3 to save the module address and bu on #4 to cancel.
It is recommended to disable autosave unless it is needed to be enabled.
