Climax FF7200, Руководство по эксплуатации, Страница: 21 / 146

P/N 59129, Rev. 9 Page 13
Setup
Receipt and Inspection
Your CLIMAX product was inspected and tested before shipment and packaged for normal
shipment conditions. CLIMAX does not guarantee the condition of your machine upon delivery.
When you receive your CLIMAX product, perform the following receipt checks:
1. Inspect the shipping containers for damage.
2. Check the contents of the shipping containers against the included invoice to ensure that
all components have been shipped.
3. Inspect all components for damage.
4. When unpacking the machine, place machine on 4-inch high blocks to prevent damaging
the components.
5. The machine is coated with a waxy preservative to prevent corrosion during shipping.
Clean this substance off the machine with solvent to prevent excess accumulation of dirt.
Contact CLIMAX immediately to report damaged or missing components.
Preparing the Machine for Use
Pre-setup Check
The FF7200 can be set up and mounted in many ways. Before setting up the flange facer, check
the following:
1. The machine assemblies are positioned correctly.
2. There is enough room to position the entire machine on or near the work piece.
3. All connections are correctly attached.
Assessing the Work Area
The FF7200 often is used in dangerous locations (in elevated positions, near other operating
equipment, overhead, etc.). CLIMAX cannot foresee where this machine will be used; therefore,
you must perform a site-specific risk assessment (see page 5) for each job before starting work.
The FF7200 has remote operation features that enable you to choose the optimum location to
work from (see the checklist on page 5).
WARNING
Always follow safe work practices, including site-specific safety
requirements. It is your responsibility to perform a risk
assessment before you set up the machine and each time before
you operate the machine.