ON
1 2
3
4
5
6
7
ON
1 2
3
4
5
6
7
1
1
1
8
10
9
13
12
7
14
1
4
5
6
11
1. Screw holes
2. Antenna
3. SMA connector
4. Address/mode selector switch
5. Input connector
6. Output connector
7. Channel LED
8. RS-485 jack
9. Status LEDs
10. RS-232 jack
11. Rail moun ng clips
12. Power input jack
13. Control bu on
14. Voice pins
3
2
1
INSTALLATION GUIDE
version 1.0.1
3
4
Change Module Address
The module address can be set from 0 to 31 by means of a dip switch called “address/mode selector
switch”. Before changing module address the main power must be disconnected. The address must
be defined in binary. For instance to set address “21”, the dip switch must be as below:
Never set the address “0” and “1” as “0” is not valid in C-Bus protocol and “1” is always
dedicated for GatewayPro module.
Check all C-Bus module addresses to avoid repe
ve address alloca on.
Switching between Direct Mode and Network Mode
To set the module in direct mode slip bu on #7 to “up” posi on or slide it “down” to set the module
in network mode.
2
1
2
3
Rail Mounting
GSM Modem is
be installed
designed to
on a standard 35 mm
wide DIN rail (EN 50022, BS 5584).
Hook the module from the top, pull down the r moun ng
ail
clips, push the module to the rail and release the r
ail
moun ng clips.
Screw Mounting
Screw the module to
surface through 4 corner screw
any
holes.
GSM Modem
(CL-DR-GSM)
1 X digital dry contact input (rising-cage 5mm screw terminals)
1 X relay channel-8A per channel (rising-cage 5mm screw terminals)
Input Voltage
Input Current
I/O Connec ons
18V-24V DC (24V DC is recommended)
100mA (for 24V DC)
C-Bus
Output
2 X RJ45
RS-232
(Direct Mode)
1 X RJ45
Input
Audio input
Audio output
Pr
oduct Specific
aon
Antenna Type
1 X 4dBi detachable omni-direc onal (RP-SMA)
